Suggestion to "fix" the hanging chip part of the A
Posted: Sun Jun 03, 2007 7:04 am
Hello,
I was wondering if it's possible to attach the little "hanging" part of the AK5 coin collector...
It attaches to the main coin collector part with a few wires, but I am concerned that it hangs down and over time the wait of the attached serial cable and power cable will pull out the pins.. and also that it hangs directly under the slot where the coins exit the AK5 device.
I'm also worried that if it ever touches the metal sides of the box the coin collector is in, that it will short out and be ruined.
Is there any way to attach this to something so it's out of the way? Do you think I could use some sticky tape on the side of the collector?
I don't want to short out the electronics or anything...
Thanks!
I was wondering if it's possible to attach the little "hanging" part of the AK5 coin collector...
It attaches to the main coin collector part with a few wires, but I am concerned that it hangs down and over time the wait of the attached serial cable and power cable will pull out the pins.. and also that it hangs directly under the slot where the coins exit the AK5 device.
I'm also worried that if it ever touches the metal sides of the box the coin collector is in, that it will short out and be ruined.
Is there any way to attach this to something so it's out of the way? Do you think I could use some sticky tape on the side of the collector?
I don't want to short out the electronics or anything...
Thanks!