Internet kiosk timer board

If you need help about Internet Cafe, Cybercafe, Kiosk, Coin Op, Self Service, you can ask here.
I may not be able to answer it. Other people may just know it and help you.
Post Reply
UfukD
Posts: 68
Joined: Sat Sep 08, 2007 2:56 am

Internet kiosk timer board

Post by UfukD »

Hi

I saw that you also sell a board with which we can use other coin acceptors from other brands to control the timer.

Some questions:

1. With what kind of cable do we connect the coin acceptor to the board?
2. From the picture on the page of that board, i make up that the board only accepts 1 signal, so we can only configure 1 kind of coin in the timer, is this true? or can we configure more coins?
3. i found another coin acceptor which i would like to use, can you maybe check if that one is ok to use with your board.

thank you
Administrator
Posts: 386
Joined: Mon Jan 15, 2007 6:38 pm

Re: Internet kiosk timer board

Post by Administrator »

1. just normal electrical cable.
2. It depends on how your coin acceptor is configured, some coin acceptor like ours can output different number of pulse according to the value of the coins.
So only one channel is enough.
The Internet Kiosk board can support most of third parties' pulse output coin acceptor and/or bill acceptor
3. I think that our interface board supports it, however you may still need to test it. We need more detail and specification of that coin acceptor.

http://www.weavefuture.com/coin_accepto ... _board.htm
UfukD
Posts: 68
Joined: Sat Sep 08, 2007 2:56 am

Re: Internet kiosk timer board

Post by UfukD »

Hi

I have the following question about the interface board.

Which voltage level is on the pulse pin when idle?
Administrator
Posts: 386
Joined: Mon Jan 15, 2007 6:38 pm

Re: Internet kiosk timer board

Post by Administrator »

It should be around 5VDC
Post Reply