I have purchased an AH5 Power system from you.
I have setup the coin accepter to recognize Australian coins.
I now need to setup the activated time per coin type, can you tell me what software I can use to configure the controller.
There is no computer connected to this AH5, it is used to control an electrical machine.
Thanks
Geoff
setup time per coin type
-
- Posts: 386
- Joined: Mon Jan 15, 2007 6:38 pm
Re: setup time per coin type
The AH5 does not need any software,
The setup up time setup the activated time per pulse is on the PCB board.
There is a button called "Setting button" on the PCB board.
Coin Op Timer Control Board setting.
The Timer Control Board takes a pulse signal from the Coin/Bill Acceptor and converts the pulse to a time on the timer (minutes per pulse).
A, input 1 coin acceptor setup, Time Setting Button 1 (labeled as setting button) for coin acceptor (input 1)
1. To set the board’s timer to a programmable mode:
Press and hold the Timer Setting Button for approximately 3 seconds. The Display will show the previous time setting. (For Example: The LED displays 008, meaning 8 minutes per pulse.)
2. To change the previous setting:
Press the Timer Setting Button for 1 second, and the Display number will increase by 1. The number goes up by 1 minute for each time it is pressed. The maximum possible number of minutes is 30 minutes. Once the timer reaches 30 minutes, it will reset back to 1 minute with another press.
3. To Change back to the working mode:
Once Steps 1 and 2 are complete, Press and hold the Timer Setting Button for another 3 seconds. The display will show the setting that is specified, and will reset back to 0.
The setup up time setup the activated time per pulse is on the PCB board.
There is a button called "Setting button" on the PCB board.
Coin Op Timer Control Board setting.
The Timer Control Board takes a pulse signal from the Coin/Bill Acceptor and converts the pulse to a time on the timer (minutes per pulse).
A, input 1 coin acceptor setup, Time Setting Button 1 (labeled as setting button) for coin acceptor (input 1)
1. To set the board’s timer to a programmable mode:
Press and hold the Timer Setting Button for approximately 3 seconds. The Display will show the previous time setting. (For Example: The LED displays 008, meaning 8 minutes per pulse.)
2. To change the previous setting:
Press the Timer Setting Button for 1 second, and the Display number will increase by 1. The number goes up by 1 minute for each time it is pressed. The maximum possible number of minutes is 30 minutes. Once the timer reaches 30 minutes, it will reset back to 1 minute with another press.
3. To Change back to the working mode:
Once Steps 1 and 2 are complete, Press and hold the Timer Setting Button for another 3 seconds. The display will show the setting that is specified, and will reset back to 0.